boostinv
2.0.0.0
|
Boost-INV click is a very useful DC/DC voltage converter device, as can output both positive and negative voltage, boosted up to 12.78V and -13.95, from a single fixed voltage input.
We provide a library for the BoostInv Click as well as a demo application (example), developed using MikroElektronika compilers. The demo can run on all the main MikroElektronika development boards.
Package can be downloaded/installed directly form compilers IDE(recommended way), or downloaded from our LibStock, or found on mikroE github account.
This library contains API for BoostInv Click driver.
void boostinv_cfg_setup ( boostinv_cfg_t *cfg );
BOOSTINV_RETVAL boostinv_init ( boostinv_t *ctx, boostinv_cfg_t *cfg );
void boostinv_default_cfg ( boostinv_t *ctx );
void boostinv_enable ( boostinv_t *ctx );
void boostinv_set_positive_voltage ( boostinv_t *ctx, uint16_t voltage );
void boostinv_set_negative_voltage ( boostinv_t *ctx, int16_t voltage );
Changes the positive and negative output voltage. Input Voltage 3.3V. Positive output voltage goes from 3200mV, 7750mV, 12000mV and 7750mV. Negative output voltage goes from -1450mV, -6700mV, -11050mV and -6700mV.
The demo application is composed of two sections :
Initializes I2C module and sets EN ( RST ) pin as output.
Changes the positive and negative output voltage every 5 sec.
The full application code, and ready to use projects can be installed directly form compilers IDE(recommneded) or found on LibStock page or mikroE GitHub accaunt.
Other mikroE Libraries used in the example:
Additional notes and informations
Depending on the development board you are using, you may need USB UART click, USB UART 2 Click or RS232 Click to connect to your PC, for development systems with no UART to USB interface available on the board. The terminal available in all Mikroelektronika compilers, or any other terminal application of your choice, can be used to read the message.