Go to the documentation of this file.
42 #ifdef PREINIT_SUPPORTED
46 #ifdef MikroCCoreVersion
47 #if MikroCCoreVersion >= 1
52 #include "drv_digital_out.h"
53 #include "drv_digital_in.h"
54 #include "drv_i2c_master.h"
66 #define TEMPLOG3_MAP_MIKROBUS( cfg, mikrobus ) \
67 cfg.scl = MIKROBUS( mikrobus, MIKROBUS_SCL ); \
68 cfg.sda = MIKROBUS( mikrobus, MIKROBUS_SDA ); \
69 cfg.int_pin = MIKROBUS( mikrobus, MIKROBUS_INT )
76 #define TEMPLOG3_RETVAL uint8_t
78 #define TEMPLOG3_OK 0x00
79 #define TEMPLOG3_INIT_ERROR 0xFF
86 #define TEMPLOG3_SLAVE_ADDR_A0_H 0x19
87 #define TEMPLOG3_SLAVE_ADDR_A0_L 0x18
94 #define TEMPLOG3_CAPABILITY_REG 0x00
95 #define TEMPLOG3_CONFIG_REG 0x01
96 #define TEMPLOG3_TEMP_UPPER_REG 0x02
97 #define TEMPLOG3_TEMP_LOWER_REG 0x03
98 #define TEMPLOG3_TEMP_CRITICAL_REG 0x04
99 #define TEMPLOG3_TEMP_AMBIENT_REG 0x05
100 #define TEMPLOG3_MANUFACT_ID_REG 0x06
101 #define TEMPLOG3_DEVICE_ID_REG 0x07
102 #define TEMPLOG3_RESOLUTION_REG 0x08
109 #define TEMPLOG3_EVENT_SHDN_STATUS_MASK 0x80
110 #define TEMPLOG3_I2C_TIMEOUT_STATUS_MASK 0x40
111 #define TEMPLOG3_HIGH_VOLT_INPUT_STATUS_MASK 0x20
112 #define TEMPLOG3_RESOLUTION_STATUS_MASK 0x18
113 #define TEMPLOG3_MEAS_RANGE_STATUS_MASK 0x04
114 #define TEMPLOG3_ACCURACY_STATUS_MASK 0x02
115 #define TEMPLOG3_ALARM_STATUS_MASK 0x01
122 #define TEMPLOG3_TLIMIT_HYST_0_DEG 0x0000
123 #define TEMPLOG3_TLIMIT_HYST_ONE_HALF_DEG 0x0200
124 #define TEMPLOG3_TLIMIT_HYST_3_DEG 0x0400
125 #define TEMPLOG3_TLIMIT_HYST_6_DEG 0x0600
126 #define TEMPLOG3_CONT_CONV_MODE 0x0000
127 #define TEMPLOG3_SHUTDOWN_MODE 0x0100
128 #define TEMPLOG3_TCRIT_LOCKED 0x0080
129 #define TEMPLOG3_TUPPER_TLOWER_LOCKED 0x0040
130 #define TEMPLOG3_INT_CLEAR 0x0020
131 #define TEMPLOG3_EVENT_OUTPUT_STATUS_MASK 0x0010
132 #define TEMPLOG3_EVENT_OUTPUT_EN 0x0008
133 #define TEMPLOG3_EVENT_ALL_TLIMIT 0x0000
134 #define TEMPLOG3_EVENT_TCRIT_ONLY 0x0004
135 #define TEMPLOG3_EVENT_POL_ACT_LOW 0x0000
136 #define TEMPLOG3_EVENT_POL_ACT_HIGH 0x0002
137 #define TEMPLOG3_EVENT_COMPARATOR_MODE 0x0000
138 #define TEMPLOG3_EVENT_INTERRUPT_MODE 0x0001
145 #define TEMPLOG3_TCRIT_DETECT 0x80
146 #define TEMPLOG3_TUPPER_DETECT 0x40
147 #define TEMPLOG3_TLOWER_DETECT 0x20
148 #define TEMPLOG3_NBYTES_ERROR 0x04
149 #define TEMPLOG3_TEMP_RANGE_ERROR 0x03
150 #define TEMPLOG3_ADDR_ERROR 0x02
151 #define TEMPLOG3_ALARMING 0x01
152 #define TEMPLOG3_OK 0x00
159 #define TEMPLOG3_12BIT_RESOLUTION 0x03
160 #define TEMPLOG3_11BIT_RESOLUTION 0x02
161 #define TEMPLOG3_10BIT_RESOLUTION 0x01
162 #define TEMPLOG3_9BIT_RESOLUTION 0x00
169 #define TEMPLOG3_EEPROM_WRITE 0x00
170 #define TEMPLOG3_SW_WRITE_PROTECT 0x01
171 #define TEMPLOG3_CLEAR_WRITE_PROTECT 0x02
178 #define TEMPLOG3_EEPROM_SIZE 256
453 #endif // _TEMPLOG3_H_
Click configuration structure definition.
Definition: templog3.h:215
uint8_t templog3_read_reg(templog3_t *ctx, uint8_t reg_addr, uint16_t *data_out)
Generic Read function.
uint8_t templog3_eeprom_sequential_read(templog3_t *ctx, uint8_t reg_addr, uint8_t *data_out, uint16_t num_bytes)
EEPROM Sequential Read function.
uint8_t resolution
Definition: templog3.h:206
void templog3_eeprom_byte_read(templog3_t *ctx, uint8_t reg_addr, uint8_t *data_out)
EEPROM Single Read function.
i2c_master_t i2c
Definition: templog3.h:199
pin_name_t int_pin
Definition: templog3.h:223
uint8_t slave_address
Definition: templog3.h:203
uint8_t templog3_write_reg(templog3_t *ctx, uint8_t reg_addr, uint16_t data_in)
Generic Write function.
void templog3_eeprom_byte_write(templog3_t *ctx, uint8_t reg_addr, uint8_t data_in, uint8_t eeprom_mode)
EEPROM Single Write function.
void templog3_default_cfg(templog3_t *ctx)
Click Default Configuration function.
uint8_t n_bytes
Definition: templog3.h:207
uint8_t slave_eeprom
Definition: templog3.h:204
void templog3_repeated_read(templog3_t *ctx, uint16_t *data_out)
Repeated Read function.
#define TEMPLOG3_RETVAL
Definition: templog3.h:76
uint8_t i2c_eeprom
Definition: templog3.h:229
digital_in_t int_pin
Definition: templog3.h:195
Click ctx object definition.
Definition: templog3.h:192
uint8_t templog3_get_temp(templog3_t *ctx, uint8_t temp_sel, float *temp_out)
Get Temperature function.
uint8_t templog3_set_temp(templog3_t *ctx, uint8_t temp_sel, float temp_in)
Set Temperature function.
uint8_t templog3_set_addr_ptr(templog3_t *ctx, uint8_t reg_addr)
Set Address Pointer function.
void templog3_eeprom_page_write(templog3_t *ctx, uint8_t reg_addr, uint8_t *data_in)
EEPROM Page Write function.
void templog3_cfg_setup(templog3_cfg_t *cfg)
Config Object Initialization function.
pin_name_t sda
Definition: templog3.h:219
void templog3_wait_conv_done(templog3_t *ctx)
Conversion Time function.
uint8_t templog3_check_alarm(templog3_t *ctx)
Alarm-Event Check function.
uint32_t i2c_speed
Definition: templog3.h:227
uint8_t dev_n_bytes
Definition: templog3.h:232
TEMPLOG3_RETVAL templog3_init(templog3_t *ctx, templog3_cfg_t *cfg)
Initialization function.
uint8_t i2c_address
Definition: templog3.h:228
pin_name_t scl
Definition: templog3.h:218
void templog3_eeprom_curr_addr_read(templog3_t *ctx, uint8_t *current_address)
EEPROM Current Address Read function.
uint8_t dev_resolution
Definition: templog3.h:231