shake2wake
2.0.0.0
|
Shake2Wake click carries an ADXL362 ultralow power, 3-axis MEMS accelerometer and ADP195 load switch. The distinguishing feature of this IC is that it incorporates several activity detection modes.
We provide a library for the Shake2Wake Click as well as a demo application (example), developed using MikroElektronika compilers. The demo can run on all the main MikroElektronika development boards.
Package can be downloaded/installed directly form compilers IDE(recommended way), or downloaded from our LibStock, or found on mikroE github account.
This library contains API for Shake2Wake Click driver.
void shake2wake_cfg_setup ( shake2wake_cfg_t *cfg );
SHAKE2WAKE_RETVAL shake2wake_init ( shake2wake_t *ctx, shake2wake_cfg_t *cfg );
void shake2wake_default_cfg ( shake2wake_t *ctx );
void shake2wake_get_lo_res_raw_data ( shake2wake_t *ctx, int8_t *x_val, int8_t *y_val, int8_t *z_val );
void shake2wake_get_raw_data ( shake2wake_t *ctx, int16_t *x_val, int16_t *y_val, int16_t *z_val )
void shake2wake_set_fifo_mode ( shake2wake_t *ctx, uint8_t mode );
This app shows the capabilities of the Shake2Wake click by reading values of an accelerometer.
The demo application is composed of two sections :
Initalizes device and applies default settings.
This is an example that shows the capabilities of the Shake2Wake click by reading values of an accelerometer and logging them on USART terminal and, in case of an interrupt, it raises voltage on the connector.
The full application code, and ready to use projects can be installed directly form compilers IDE(recommneded) or found on LibStock page or mikroE GitHub accaunt.
Other mikroE Libraries used in the example:
Additional notes and informations
Depending on the development board you are using, you may need USB UART click, USB UART 2 Click or RS232 Click to connect to your PC, for development systems with no UART to USB interface available on the board. The terminal available in all Mikroelektronika compilers, or any other terminal application of your choice, can be used to read the message.