boostinv2
2.0.0.0
|
Boost-INV 2 Click is a very useful DC/DC voltage converter device, as can output both positive and negative voltage, boosted up to 15V and inverted to -15V, from a single fixed voltage input.
We provide a library for the boostinv2 Click as well as a demo application (example), developed using MikroElektronika compilers. The demo can run on all the main MikroElektronika development boards.
Package can be downloaded/installed directly form compilers IDE(recommended way), or downloaded from our LibStock, or found on mikroE github account.
This library contains API for boostinv2 Click driver.
void boostinv2_cfg_setup ( boostinv2_cfg_t *cfg );
BOOSTONV2_RETVAL boostinv2_init ( boostinv2_t *ctx, boostinv2_cfg_t *cfg );
void boostinv2_default_cfg ( boostinv2_t *ctx );
void boostinv2_set_positive_voltage ( boostinv2_t *ctx, uint16_t voltage );
void boostinv2_set_negative_voltage ( boostinv2_t *ctx, uint16_t voltage );
void boostinv2_generic_transfer ( boostinv2_t *ctx, spi_master_transfer_data_t *block );
First increse positiv voltage by 2V every 3 seconda, then decrese negative value for -2v every 3 seconds.
The demo application is composed of two sections :
Initializes Driver init and enable chip
Changes the positive and negative output voltage. Positive output voltage goes from 5V to 15V. Negative output voltage goes from -5V to -15V
The full application code, and ready to use projects can be installed directly form compilers IDE(recommneded) or found on LibStock page or mikroE GitHub accaunt.
Other mikroE Libraries used in the example:
Additional notes and informations
Depending on the development board you are using, you may need USB UART Click, USB UART 2 Click or RS232 Click to connect to your PC, for development systems with no UART to USB interface available on the board. The terminal available in all Mikroelektronika compilers, or any other terminal application of your choice, can be used to read the message.