fan
2.0.0.0
|
Fan Click carries an EMC2301 controller for powering and regulating the operation of 5V four-wire fans, which are commonly utilized as coolers in computers and other electronics.
We provide a library for the Fan Click as well as a demo application (example), developed using MikroElektronika compilers. The demo can run on all the main MikroElektronika development boards.
Package can be downloaded/installed directly form compilers IDE(recommended way), or downloaded from our LibStock, or found on mikroE github account.
This library contains API for Fan Click driver.
void fan_cfg_setup ( fan_cfg_t *cfg );
void fan_generic_write ( fan_t *ctx, uint8_t reg, uint8_t *data_buf, uint8_t len );
void fan_generic_read ( fan_t *ctx, uint8_t reg, uint8_t *data_buf, uint8_t len );
void fan_lock_registers ( fan_t *ctx, uint8_t lock );
This application is controller for powering and regulating.
The demo application is composed of two sections :
Initialization driver init and init chip.
Performs a control of the fan and reads rotation per minute (RPM). Results will be sent to the usb uart terminal.
The full application code, and ready to use projects can be installed directly form compilers IDE(recommneded) or found on LibStock page or mikroE GitHub accaunt.
Other mikroE Libraries used in the example:
Additional notes and informations
Depending on the development board you are using, you may need USB UART click, USB UART 2 Click or RS232 Click to connect to your PC, for development systems with no UART to USB interface available on the board. The terminal available in all Mikroelektronika compilers, or any other terminal application of your choice, can be used to read the message.