irgesture2
2.0.0.0
|
PRVIH_PAR_RECENICA_SA_PRODUCT_PAGE_DA_ISPRATE_CELINU
[click Product page](CLICK_PRODUCT_PAGE_LINK)
We provide a library for the IR Gesture 2 Click as well as a demo application (example), developed using MikroElektronika compilers. The demo can run on all the main MikroElektronika development boards.
Package can be downloaded/installed directly from NECTO Studio Package Manager(recommended way), downloaded from our LibStock™ or found on Mikroe github account.
This library contains API for IR Gesture 2 Click driver.
irgesture2_cfg_setup
Config Object Initialization function. irgesture2_init
Initialization function. irgesture2_default_cfg
Click Default Configuration function. irgesture2_get_int_pin
This function returns the INT pin logic state. irgesture2_read_pixels
This function reads the raw ADC values of entire 60-pixel IR photodiode array. irgesture2_write_register
This function writes a data byte to the selected register by using SPI serial interface. This example demonstrates the use of IR Gesture 2 click board by reading and displaying the raw ADC values of entire 60-pixel IR photodiode array.
The demo application is composed of two sections :
Initializes the driver and performs the click default configuration.
Waits for an end of conversion interrupt and then reads the raw ADC values of entire
60-pixel IR photodiode array and displays the results on the USB UART as a 10x6 matrix every 100ms approximately.
The full application code, and ready to use projects can be installed directly from NECTO Studio Package Manager(recommended way), downloaded from our LibStock™ or found on Mikroe github account.
Other Mikroe Libraries used in the example:
Additional notes and informations
Depending on the development board you are using, you may need USB UART click, USB UART 2 Click or RS232 Click to connect to your PC, for development systems with no UART to USB interface available on the board. UART terminal is available in all MikroElektronika compilers.