TOP Contributors

  1. MIKROE (2784 codes)
  2. Alcides Ramos (405 codes)
  3. Shawon Shahryiar (307 codes)
  4. jm_palomino (133 codes)
  5. Bugz Bensce (97 codes)
  6. S P (73 codes)
  7. dany (71 codes)
  8. MikroBUS.NET Team (35 codes)
  9. NART SCHINACKOW (34 codes)
  10. Armstrong Subero (27 codes)

Most Downloaded

  1. Timer Calculator (142088 times)
  2. FAT32 Library (75339 times)
  3. Network Ethernet Library (59511 times)
  4. USB Device Library (49530 times)
  5. Network WiFi Library (45314 times)
  6. FT800 Library (44944 times)
  7. GSM click (31454 times)
  8. mikroSDK (30478 times)
  9. microSD click (27806 times)
  10. PID Library (27626 times)
Libstock prefers package manager

Package Manager

We strongly encourage users to use Package manager for sharing their code on Libstock website, because it boosts your efficiency and leaves the end user with no room for error. [more info]

< Back
Project

RGB Driver click demo example

Rating:

0

Author: MIKROE

Last Updated: 2018-07-05

Package Version: 1.0.0.0

Category: LED segment

Downloaded: 276 times

Not followed.

License: MIT license  

This example is made to demonstrate the operation of the RGB Driver click.

No Abuse Reported

Do you want to subscribe in order to receive notifications regarding "RGB Driver click demo example" changes.

Do you want to unsubscribe in order to stop receiving notifications regarding "RGB Driver click demo example" changes.

Do you want to report abuse regarding "RGB Driver click demo example".

  • Information
  • Comments (0)

Project Blog

RGB Driver click

RGB Driver click

Example that demonstrates the functionality of RGB Driver Click

View full image

This example is made to demonstrate the operation of the RGB Driver click.

The user can select the color by moving the R / G / B slider to the desired position.

Once the new color is set, the RGB Driver click will display that color on the RGB LED tape.

Hardware

- EasyMX PRO v7 for STM32

  •   MikroBUS 1 - RGB Driver click
  •   EasyTFT 

Packages

ALSO FROM THIS AUTHOR

ISO ADC Click

0

The ISO ADC Click is add-on board current-shunt measurement device with isolated delta-sigma modulator. This Click board™ is based on AMC1204BDWR provide a single-chip solution for measuring the small signal of a shunt resistor across an isolated barrier from Texas Instruments. ISO ADC Click contains shunt resistor, these types of resistors are typically used to sense currents in motor control inverters, green energy generation systems, and other industrial applications.

[Learn More]

Relay 2 Click

0

Relay 2 Click is a dual relay Click board™, equipped with two single-pole solid state relays (SSR), built with the patented OptoMOS® technology.

[Learn More]

6DOF IMU 2 click

3

6DOF IMU 2 click is a mikroBUS add-on board with Bosch's BMI160 low power inertial measurement unit (IMU). The BMI160 is capable of precise acceleration and angular rate (gyroscopic) measurement. 6DOF IMU 2 click communicates with the target MCU through the I2C or SPI bus (user-selectable).

[Learn More]