Code Categories
- Audio & Speech (64)
- Communication (473)
- Graphics & LCD (285)
- GSM / GPRS (27)
- GPS (28)
- Measurement (498)
- Power supply (67)
- Storage (50)
- Timers (Real time clock) (111)
- Other Codes (248)
- Internal MCU modules (60)
- Gaming and Fun (56)
- RFid (14)
- Motor Control (119)
- Bootloaders (16)
- Development Systems (56)
TOP Contributors
- MikroElektronika Team (598 codes)
- Shawon Shahryiar (250 codes)
- Alcides Ramos Zambrano (143 codes)
- Dany (66 codes)
- S P (63 codes)
- MikroBUS.NET Team (35 codes)
- NART SCHINACKOW (34 codes)
- FOURNET Olivier (25 codes)
- Alberto Trasimeni (25 codes)
- Roman Toropov (25 codes)
Most Downloaded
- Timer Calculator (86432 times)
- FAT32 Library (42385 times)
- Network Ethernet Library (41232 times)
- USB Device Library (31856 times)
- Network WiFi Library (29845 times)
- FT800 Library (23631 times)
- PID Library (20317 times)
- GSM click (20189 times)
- microSD click - Example (16881 times)
- GPS click - Example (13565 times)
Package Manager
We strongly encourage users to use Package manager for sharing their code on Libstock website, because it boosts your efficiency and leaves the end user with no room for error. [more info]
UPS Click
Rating:
Author: MikroElektronika Team
Last Updated: 2018-02-28
Category: Power supply
Downloaded: 288 times
Not followed.
UPS click is a supercapacitor charger click that provides continuous power for a load connected to the output terminals, even after the power supply is removed.
Do you want to subscribe in order to receive notifications regarding "UPS Click" changes.
Do you want to unsubscribe in order to stop receiving notifications regarding "UPS Click" changes.
Do you want to report abuse regarding "UPS Click".
- Information
- Comments (0)
mikroSDK Library Blog
Library Description
This library presents some generic functions for controlling the Click board.
Key functions:
- void usp_setMode(uint8_t mode); - The functions for settings chip mode.
- uint8_t ups_getPowerGood(); - The functions for reading the PGD state.
Examples Description
The demo application is composed of three sections:
- System Initialization - Initializes CS pin as INPUT and RST pin as OUTPUT.
- Application Initialization - Initializes Driver init and setting chip mode as ACTIVE.
- Application Task - (code snippet) - checks the state of PGD (Power Good), PGD goes high when Vout is within 6% of the target value (4.98V).
void applicationTask()
{
PGD_State = ups_getPowerGood();
if( PGD_State != 0)
{
mikrobus_logWrite("--- Power Good ", _LOG_LINE);
}
Delay_1sec();
}
mikroE Libraries used in the example:
- UART Library
- Conversions Library
- C_String Library
Additional notes and information
Depending on the development board you are using, you may need USB UART click, USB UART 2 click or RS232 click to connect to your PC, for development systems with no UART to USB interface available on the board. The terminal available in all MikroElektronika compilers, or any other terminal application of your choice, can be used to read the message.