Use your forum account to login.

LOGIN

TOP Contributors

  1. MikroElektronika Team (452 codes)
  2. Shawon Shahryiar (246 codes)
  3. Alcides Ramos (97 codes)
  4. Dany (66 codes)
  5. O B (61 codes)
  6. MikroBUS.NET Team (35 codes)
  7. NART SCHINACKOW (34 codes)
  8. Alberto Trasimeni (25 codes)
  9. Roman Toropov (25 codes)
  10. Arezki YOUYOU (24 codes)

Most Downloaded

  1. Timer Calculator (78341 times)
  2. Network Ethernet Library (38043 times)
  3. FAT32 Library (37062 times)
  4. USB Device Library (28701 times)
  5. Network WiFi Library (27410 times)
  6. FT800 Library (20161 times)
  7. PID Library (19026 times)
  8. GSM click - Example (18596 times)
  9. microSD click - Example (15965 times)
  10. GPS click - Example (12784 times)
Libstock prefers package manager

Package Manager

We strongly encourage users to use Package manager for sharing their code on Libstock website, because it boosts your efficiency and leaves the end user with no room for error. [more info]

< Back
Library

UV 3 click

Rating:

Author: MikroElektronika Team

Last Updated: 2017-08-10

Category: Measurement

Downloaded: 161 times

Not followed.

UV 3 click is an advanced ultraviolet (UV) light sensor with I2C protocol interface. The click carries VEML6070 UVA light sensor designed by the CMOS process. UV 3 click runs on either 3.3V or 5V power supply.

No Abuse Reported

Do you want to subscribe in order to receive notifications regarding "UV 3 click" changes.

Do you want to unsubscribe in order to stop receiving notifications regarding "UV 3 click" changes.

Do you want to report abuse regarding "UV 3 click".

  • Information
  • Comments (0)

Library Blog

UV 3 click

UV 3 click

Front and back view of the UV 3 click board.

View full image

ALSO FROM THIS AUTHOR

CANculator

CANculator is a software development tool used for easier CAN baud rate calculation and manipulation of the CAN bus parameters.

[Learn More]

BarGraph click - Example

This is a demonstration example for BarGraph click. Bar Graph is representing ADC value measured on Poetntiometer P1. On Potentiometer P2 user can adjust PWM for LCD backlight.

[Learn More]

IQRF click

IQRF click carries the DCTR-76DA RF transceiver, operating in the 868/916 MHz frequency. The click is designed to run on a 3.3V power supply. It communicates with the target microcontroller over SPI or UART interface.

[Learn More]