Code Categories
- Audio & Speech (64)
- Communication (476)
- Graphics & LCD (286)
- GSM / GPRS (29)
- GPS (28)
- Measurement (504)
- Power supply (70)
- Storage (50)
- Timers (Real time clock) (112)
- Other Codes (248)
- Internal MCU modules (63)
- Gaming and Fun (56)
- RFid (14)
- Motor Control (121)
- Bootloaders (16)
- Development Systems (57)
TOP Contributors
- MikroElektronika Team (612 codes)
- Shawon Shahryiar (252 codes)
- Alcides Ramos Zambrano (143 codes)
- Dany (66 codes)
- S P (63 codes)
- MikroBUS.NET Team (35 codes)
- NART SCHINACKOW (34 codes)
- FOURNET Olivier (25 codes)
- Alberto Trasimeni (25 codes)
- Roman Toropov (25 codes)
Most Downloaded
- Timer Calculator (87414 times)
- FAT32 Library (43680 times)
- Network Ethernet Library (41796 times)
- USB Device Library (32350 times)
- Network WiFi Library (30190 times)
- FT800 Library (24343 times)
- PID Library (20455 times)
- GSM click (20400 times)
- microSD click - Example (16989 times)
- GPS click - Example (13649 times)
Package Manager
We strongly encourage users to use Package manager for sharing their code on Libstock website, because it boosts your efficiency and leaves the end user with no room for error. [more info]
LED Driver 4 click
Rating:
Author: MikroElektronika Team
Last Updated: 2018-01-04
Category: Power supply
Downloaded: 302 times
Not followed.
LED Driver 4 click is a form of a high-efficiency boost converter that is ideally suited for driving an array of white LEDs. The driver has the ability to dim the connected LED array, without producing any noise on the output.
Do you want to subscribe in order to receive notifications regarding "LED Driver 4 click" changes.
Do you want to unsubscribe in order to stop receiving notifications regarding "LED Driver 4 click" changes.
Do you want to report abuse regarding "LED Driver 4 click".
- Information
- Comments (0)
mikroSDK Library Blog
Library Description
The library carries functions necessary to have complete control over all functionalities of the Click board.
Examples Description
The demo application is composed of three sections:
- System Initialization - Necessary registers and GPIO configuration.
- Application Initialization - PWM Initizalization and Start of PWM signal.
- Application Task - (code snippet) - Sequential change of the brightness from
minimum to maximum value.
void applicationTask()
{
dutyCycle += 50;
PWM_TIM5_Set_Duty(dutyCycle, _PWM_NON_INVERTED, _PWM_CHANNEL1);
if (dutyCycle > pwmPeriod )
dutyCycle = 0;
Delay_ms(2);
}
Other mikroE Libraries used in the example:
- PWM
Additional notes and information
Depending on the development board you are using, you may need USB UART click, USB UART 2 click or RS232 click to connect to your PC, for development systems with no UART to USB interface available on the board. The terminal available in all MikroElektronika compilers, or any other terminal application of your choice, can be used to read the message.