Library Description

This library has ability to perform a full control of the AD-SWIO Click board. This click can convert and measure voltage, current and resistance from 4 independent channels and 4 different diagnostics.

Key functions:

• adswio_err_t adswio_enable_ch( uint8_t channel ) - This function allows user to enable the desired channel/channels.
• adswio_err_t adswio_set_ch_func( uint8_t channel, uint8_t ch_func ) - This function allows user to modify the functionality of the selected channel.
• adswio_err_t adswio_get_conv_results( uint8_t channel, uint16_t *data_out ) - This function allows user to get the converted results of the selected channel.

Examples description

The application is composed of three sections :

• System Initialization - Initializes all necessary peripherals and pins used for this click. Also initializes uart console module.
• Application Initialization - Performs a hardware reset of the click board and executes a default configuration which includes that channel A will be enabled to measure voltage input in the range from 0V to 10V, with 4k8 SPS sample rating. In this function also Silicon Revision ID will be checked.
• Application Task - (code snippet) - Waits until data from the enabled channel is ready and then reads results of conversion for channel A and if response is ok, prints the results on the uart console.

void application_task( )
{
    adswio_rdy = adswio_status_pin_ready( );

    while ( adswio_rdy == 0 )
    {
        adswio_rdy = adswio_status_pin_ready( );
    }

    adswio_err = adswio_get_conv_results( _ADSWIO_SETUP_CONV_EN_CHA,
                                          &adswio_ch_a );

    if ( adswio_err == _ADSWIO_ERR_STATUS_OK )
    {
        adswio_res = adswio_ch_a;
        adswio_res /= _ADSWIO_RANGE_RESOLUTION;
        adswio_res *= _ADSWIO_RANGE_VOLT_MV;
        adswio_ch_a = adswio_res;

        WordToStr( adswio_ch_a, adswio_log );
        Ltrim( adswio_log );

        mikrobus_logWrite( "* CH A converted result is ", _LOG_TEXT );
        mikrobus_logWrite( adswio_log, _LOG_TEXT );
        mikrobus_logWrite( " mV", _LOG_LINE );
        Delay_ms( 100 );
    }
}

Additional Functions :

• Application Default Handler - Used to send error report messages from click driver to initialized console module.

Other mikroE Libraries used in the example:

• Conversions
• C_String
• SPI
• UART

Additional notes and informations

Depending on the development board you are using, you may need USB UART click, USB UART 2 click or RS232 click to connect to your PC, for development systems with no UART to USB interface available on the board. The terminal available in all MikroElektronika compilers, or any other terminal application of your choice, can be used to read the message.