We strongly encourage users to use Package manager for sharing their code on Libstock website, because it boosts your efficiency and leaves the end user with no room for error. [more info]
posted on 2015/01/09 02:46:40 PM CET
Hi i want to use a 16f887 at 20.00mhz on a picready1
port b is input and need all inputs to trigger on 1 to 0 transition.
to set port d and c as outputs and normal setting as 0x55 (no alarm)
8 inputs have 2 outputs each for green and red led. using port d and c for these.
i need to use port b as interrupt triggered so that leds swap on alarm for corresponding input
also have to have a trigger from each alarm to send a signal to a phone dial-er
need a reset button to reset alarm condition.
Iam using mikroe pro ver 6.40 and would much appreciate anyone's help on here.
Have to be able to reset the fault condition once the pump is running again ie float is active. also need a bypass for each input which turns off the green run led but tricks the chip into thinking everything is normal.
