We strongly encourage users to use Package manager for sharing their code on Libstock website, because it boosts your efficiency and leaves the end user with no room for error. [more info]
posted on 2013/04/07 09:31:56 AM CEST
I buy serial 7 seg 8 digits and my new board EasyPICPRO 7 and I am trying to test it by very simple example.
anyone have an example for this.
thanks,
posted on 2013/03/28 05:30:15 AM CET
Hi
l am trying to replace a standard dpdt three position switch (on-off-on) with something a bit smarter.
I have a 12F675 I want to use with a momentary switch to toggle on-off-auto and provide high/low outputs the same as a three pos switch. I also want an RGB led to indicate the switches current state via three colors. The idea would be to have single button presses for on and off, but a long press/hold to go into auto mode and single press to cancel auto.
Ive searched everywhere for a solution but haven't found anything. Can one of you point me in the right direction of an example or a project someone else has come up with?
Thanks.
posted on 2013/01/30 11:25:52 PM CET
hi,
i nee code in microc for the following
2 toggle switches and 8 leds
sw1 and sw2 off means = all leds off
if sw1 on - led1 on- 5 millisecond delay-led2 on- 5 millisecond delay-led 3 on-1millisecond delay-led3 off-10 millisecond delay- led4 on 1msec delay -led4 off. thishould repeat in loop and should also check if sw2 is on if it is on then all led off
the same for if sw2on.
posted on 2013/01/30 09:10:54 AM CET
Hello everyone,
Tomorrow I have to hand a mini project I was asked to make as a homework. I'm still a beginner and I can't understand the syntax very well so I couldn't write the code .. I surfed the net for solutions but couldn't find anything helpful so i'm hoping someone can help me ASAP.
Here's the information that should help:
-Pic 16F886
-Quartz 8MHz
Here's the homework :
Using "interrupt" and "TMR" commands, turn on 2 leds together, but each one will be turned off and on again with a different frequency (they don't have the same timer).
Waiting for your answers.
Sincerely,
Elmira
posted on 2012/12/21 08:55:22 AM CET
Dear,
I am very much interested in PIC micro-controller.
But i can't proceed ahead because i don't have any scheme of MPPT charge controller based PIC controller (16F8xx) (200 watts) . I will be very much happy if any one can give more details about circuit scheme (with sample), necessary code. I will be very much thankful to that person.
email: amar.dz23@gmail.com
I will be thank you.
